EAN: 6977905741236
Creality SpacePi X4 Filament Dryer
Creality SpacePi X4 is a powerful dual-chamber filament dryer, allowing you to dry as many as 4 spools simultaneously with full temperature control from 45 to 85°C. Thanks to the active drying technology, fast heating and quiet operation, you will prepare PLA, PETG, TPU, ABS or PA-CF filaments for printing in a reproducible and stable way, eliminating the problem of moisture, bubbles and shagging during printing.
Dry a variety of filaments
The device features two independently controlled heating chambers, allowing you to set different temperatures for different filaments (e.g. 50°C for PLA and 85°C for PA-CF). You can use one or both chambers as needed, which saves time and energy in a small workshop or when working with different materials at the same time.
Speed and uniformity
With 200W + 200W PTC heaters, SpacePi X4 heats up to 85°C in about 20 minutes. The 360° air circulation ensures even heat distribution, and the SpaceDry 4.0 technology with active dehumidification and desiccant regeneration guarantees effective moisture removal without changing cartridges.
Quiet, cheap, efficient
The Active Silent system keeps noise levels to just 43-46 dB, allowing you to work comfortably at home and in the workshop. The Creality SpacePi X4 offers energy-efficient operation with an energy consumption of 0.124 kWh in single-chamber mode and 0.208 kWh in dual-chamber mode, reducing the cost of preparing filaments for printing.
Wide compatibility
The Creality SpacePi X4 filament dryer supports spools up to 200 mm in diameter and 150 mm in width with 1.75 mm and 2.85 mm diameter filaments. So you can dry both standard 1 kg spools and larger spools weighing 2 kg.
Safe operation
The Creality SpacePi X4's triple protection system includes fan control, heater temperature protection and sensors that monitor the temperature in the chambers. This allows you to use the device without worrying about overheating or damaging the filaments.
Everyday convenience
The dryer is equipped with a chamber backlight, a sliding lock, anti-burn rollers and a moisture-proof seal to ensure comfort. In addition, the device signals the end of drying with a sound, making it easy to use.
You control as you please
The EDry UI panel allows you to precisely control drying parameters, including temperature, drying time (1-48 hours) and threshold humidity. You can use automatic modes or custom settings to tailor the drying process to the requirements of your specific filament.
Included:
- Filament dryer
- Power cord
- User manual
| Manufacturer | Creality |
|---|---|
| Model | SpacePi X4 |
| Manufacturer code | 4005010100 |
| Rated power | 360W |
| Temperature range | 45~85°C |
| Drying time | 1-48 h |
| Input voltage | 220-240V50/60Hz |
| Supported filament | Spool diameter: ≤200 mm Width: ≤150 mm Filament diameter: 1.75 / 2.85 mm |
| Dimensions | 382 × 290 × 270 mm |
| Weight | 5 kg |
Note: Product descriptions are automatically generated based on the information provided by our suppliers.
Despite our care in presenting the content, translation errors or inaccuracies may occur.
If you have any doubts, please contact us before making your purchase.
Thank you for your understanding.
