Tempered glass Spigen ALM S Glas.tR Slim Anti Reflection is a screen protector featuring an advanced AR anti-reflection coating that significantly reduces sunlight glare and keeps the display readable even in bright outdoor conditions. 9H hardness effectively shields the screen from everyday scratches, while the high touch sensitivity ensures the display responds exactly as if no glass were there at all.

The slim design houses 5 technological layers: an oleophobic coating to minimize smudges and fingerprints, 9H glass, an OCA layer for full clarity, a shatter-proof film, and silicone resin for bubble-free adhesion. The glass is compatible with a wide range of cases — the edges are slightly narrower than the screen, preventing any gap between the glass and the case while keeping the entire active display area protected. The MIL-STD 810G-516.6 certification (drop test - PASS) confirms its drop resistance.

Installation is quick and easy thanks to the AlignMaster system with a positioning tray — the glass lands dust-free and perfectly aligned in just 3 steps, with no air bubbles or smears. The 2-Pack includes two pieces of glass with installation kits.

• 100% Original
• Packed in original packaging
• AR anti-reflective coating
• 5-layer construction
• MIL-STD 810G-516.6 certified (drop test - PASS)
• High touch sensitivity
• Oleophobic coating 
• Easy installation

2 × Spigen ALM S Glas.tR Slim Anti Reflection tempered glass

2 × AlignMaster installation tray

2 × Installation kit

1. Start the installation in the bathroom right after a shower – the steam will absorb all the dust from the air so it won't interfere with the process.
2. Thoroughly clean and degrease the screen surface, then polish it to a shine with a dry cloth. Make sure no dust particles remain.
3. Place the frame with the glass already attached onto the phone – it ensures precise alignment and makes application easier.
4. Pull the starter film to begin the automatic process of adhering the glass to the screen.
5. Press down on the glass at the designated spots. Do this carefully so that the adhesive layer bonds well with the surface.
6. Remove the frame and eliminate any air bubbles by sliding your finger in circular motions.